infinity_nimish

i am not getting ur doubt. the explanation is simple. dc source creates diff of +V volts and gnd.

first of all you need to go through the entire xbee 802.15.4 document on digi.com n multi hopping is easy. say node 1,2 n 3 node1's destination address is node...

did u try 100,75 rpm high torque motors like 10 kg, 15 kg

youtube has abundant videos. search pcb making iron method as for chemicals u'll need vodka, nailpolish remover and ferrous chloride(available at component shops) for drilling holes u'll need PCB hand...

do you know to operate the zigbee module? i have operated on xbee 802.15.4 but not with zigbee. i think it too has transparent mode and api mode

well there are ready made servo controllers in the market. i personally fell you should get one ready made, use it and learn from it. i dont know how AC...

i have worked with atmega 16 but not with pic. at C level there might not be much of a difference actually.one can use any. but if you are required...

thanks everyone for a good welcome ishutopreWelcome to CrazyEngineers forum Nimish. Tell us how did you found out about CE?The_Big_KWelcome to CE, Nimish 😀 We hope you will enjoy CE....

hi I am nimish from Mumbai and i am in final year electronics engineering. hope to learn a lot from the community and give to it at the same time...