CrazyEngineers
CrazyEngineers
Stephen_c

Stephen_c

Member

Stephen_c is a member of CrazyEngineers since Sep 14, 2009

Member since

Sep 14, 2009

Last active

Jul 18, 2010

Posts contributed

21

Recent posts

Jul 18, 2010
well at infy all you need to do is clear the aptitude test and show some confidence in your interview... interview is only hr and is really a cake walk.......
Jun 15, 2010
I would actually like to knwo the entry level job for an electronics and telecom engineer on oil rigs. the jobs profile which i found was suitable for me were...
Jun 1, 2010
Infosys 3.25 lpa
May 31, 2010
Hi, I would like CEans to help me in this one. What job can a Electronics and Telecom engineer can get on an oil rigg and how to go about...
May 31, 2010
I am placed at infy... and believe it or not i never had any strategy for the interview.. all you have to do is clear the aptitude test which is...
May 22, 2010
so max output u will get is 2.5 volts.. either u configure your adc to accept 2.5 volt as high value or use an op-amp to convert value to 5V.....
May 22, 2010
if it is under warranty then just find out the service center if not then it is very difficult to repair motherboards
May 22, 2010
well according to me... u are dividing your vcc by 512 for each inch...as a result you are getting 9.8mV/inch but if u consider the range of 254 inch the...
May 22, 2010
but wont the engine which runs the drive also matter??.. so if the engine can provide more power to the drive the speed will increase... am i right??
Dec 13, 2009
Re: plz help me out...decision to be taken You can try weight sensors as different coins have different weights. But than this will be a very easy project and not...
Home Channels Search Login Register