pratik20990
@pratik20990-Y0V1iW Member
- Member since
- Joined
- Last active
- Active
- Member number
- Member #42,587
- Posts
- 11
- Replies
- 11
- Reactions
- 0
- Active days
- 0
Contributions
Last 12 months
0 contributions
- Active days
- 0
- Longest run
- 0 days
- Current run
- 0 days
Trophies
Featured trophies
0 / 8
Swipe or scroll to see more trophies
-
Replied #Threads
line follower dc motors problem
silverscorpionHow much voltage are you giving the motors? And how much to the sensors? You might want to check if the sensors are working properly after...
-
Replied #Threads
Learn Robotics-3 - Introductin to a Line Follower..
silverscorpionI think you're mistaken. If the width of the line is 20 cm, and the robot has to follow that line, then the width of the...
-
Replied #Threads
l293d motor driver IC help
silverscorpionWell, I dont get your question.. What's the problem in giving two different voltages to 2 pins in the same IC?? Pins 1 and 9 (Enable...
-
Replied #Threads
problem in IR sensor circuit
just2rockyes check POT with preset value check & calculate 5k or so.reverse ploarity for IR D1 at OPAMP PIN6,same for against 100 ohm resistance...pls check resistance...
-
Replied #Threads
problem in IR sensor circuit
MuffyReverse polarity of receiver diode . The diode labeled "IR receiver D1" , connect the anode of diode to pin 6 of lm324 and the cathode...
-
Replied #Threads
problem in IR sensor circuit
Muffy@pratik20990 : Reverse bias the receiver diode, inter change the polarity . It should work. When ir is indecent on the diode the reverse leakage current...
Activity by month
Where pratik20990 contributes
-
#Threads 22 · 100%
Highlights
- Reactions per contribution
- 0.0
- Best answers
- 0
- Member for
- 17 years