CrazyEngineers
CrazyEngineers
pratik20990

pratik20990

Member

pratik20990 is a member of CrazyEngineers since Jun 30, 2009

Member since

Jun 30, 2009

Last active

Feb 18, 2010

Posts contributed

22

Recent posts

Feb 18, 2010
I have four 3.7V 1400mAh Li-ion batteries that are to be connected in series so as to get resultant voltage of 14.8V and 1400mAH current rating. My problem is that...
Feb 7, 2010
silverscorpionHow much voltage are you giving the motors? And how much to the sensors? You might want to check if the sensors are working properly after the motors stopped running....
Feb 7, 2010
Hi, I have made a line follower bot circuit consisting of AT89S52 MCU, 2 IR sensors with lm324 op-amp and l293d motor driver IC. My motor specifications are 24V,200rpm. When...
Jan 30, 2010
please suggest some best books for learning 8051 assembly programming....
Jan 22, 2010
I want to make an ISP(In System Programmer) for AT89S52 Microcontroller. Can anyone provide me some links for complete info regarding this.😒
Jan 19, 2010
silverscorpionI think you're mistaken. If the width of the line is 20 cm, and the robot has to follow that line, then the width of the robot also has to...
Jan 15, 2010
Can anyone tell me about any software for PCB schematic design that has the complete library of components. I have tried two software - Eagle 5.7.0 which does not have...
Jan 1, 2010
silverscorpionWell, I dont get your question.. What's the problem in giving two different voltages to 2 pins in the same IC?? Pins 1 and 9 (Enable pins) are to be...
Dec 28, 2009
I am using L293D motor driver for line follower which has the following pin configuration- In this at Pin no. 8 we have to apply the voltage at which we...
Dec 7, 2009
hello, i am using AT89S52 in my project and i want to know how can i burn any program on it(i mean to know about the hardware)..........please anyone from delhi...
Home Channels Search Login Register