vish4me
@vish4me-xPzMBQ Member
- Member since
- Joined
- Last active
- Active
- Member number
- Member #38,163
- Posts
- 7
- Replies
- 7
- Reactions
- 0
- Active days
- 0
Contributions
Last 12 months
0 contributions
- Active days
- 0
- Longest run
- 0 days
- Current run
- 0 days
Trophies
Featured trophies
0 / 8
Swipe or scroll to see more trophies
-
Replied #Threads
calculation of torque in a rectangular section
hi, i used the formulae torque=I*alpha. the section mounted on shaft should rotate by 180 degrees in 25 minutes. so the speed of shaft came to...
-
Replied #Threads
o-rng gland design
I have a doubt. how do you select the cross-section dia of o-ring. this seems to the starting point in designing the o-ring glnd. Thank you.
-
Replied #Threads
calculation of torque in a rectangular section
hi, i am doing a project on frame tilting arrangement where the sheet metal stacks mounted on a shaft have to be rotated by 180 degrees....
-
Replied #Threads
calculation of torque in a rectangular section
hi, in this case, the shaft c/s is circular. but a rectangular c/s load is mounted on the shaft. how do i calculate the torque.
-
Replied #Threads
design of shafts
i checked the formulae ...... Mt=95550*1000*N/n where N is power in kW. n=speed of shaft in rpm. the formulae for dia is also the same i...
-
Replied #Threads
Minimum speed available for an 8 hp dc electric motor with torque of 37 kn-m
Re: electric motor hey thanks a lot guys for the help
-
Replied #Threads
design of shafts
the shaft carries about 15000 kgs distributed load. it has to rotate 180 degrees in 25 minutes. it is powered by an electric motor of 7...
Activity by month
Where vish4me contributes
-
#Threads 14 · 100%
Highlights
- Reactions per contribution
- 0.0
- Best answers
- 0
- Member for
- 17 years