maxz
@maxz-iHZPgv Member
- Member since
- Joined
- Last active
- Active
- Member number
- Member #32,630
- Posts
- 11
- Replies
- 37
- Reactions
- 0
- Active days
- 0
Contributions
Last 12 months
0 contributions
- Active days
- 0
- Longest run
- 0 days
- Current run
- 0 days
Trophies
Featured trophies
0 / 8
Swipe or scroll to see more trophies
-
Replied #Threads
Car Brake System~!!!! How to improve it?
well~ for my project, i just studies on the design of the braking plate and the material of it only. as i mentioned, no sponsors. so...
-
Replied #Threads
Car Brake System~!!!! How to improve it?
I see.... but i think there's some alternative way to use on the improvement.. since i graduated, i never look on the research already. Moreover, there...
-
Replied #Threads
Car Brake System~!!!! How to improve it?
Thank you again for all. I'm here and yes, i have graduated from my University.
-
Replied #Threads
Car Brake System~!!!! How to improve it?
Finally i had a break through and my project were a success. I had a Grade B on my Project and i'm very proud and thank...
-
Replied #Threads
Stress Analysis Using Autodesk Inventor 2010
Dear Juma... What happen with inventor 2010??? I do all the steps but i couldnt get wat u did in here... it shows only displacement and...
-
Replied #Threads
Stress Analysis Using Autodesk Inventor 2010
Omg Juma~!! U're really Helpful... and this thing i saw it before in Inventor.. and i was like wtf was this... so i doesnt care much...
-
Replied #Threads
Stress Analysis Using Autodesk Inventor 2010
thx juma~!! It would be appreciate if u write it step by step how to set those configurations.
-
Replied #Threads
Circular Plate Bending Moment and Stress
btw wat is design accelerator formulas??? where can i get it?
-
Replied #Threads
Stress Analysis Using Autodesk Inventor 2010
Dear Juma, I have roughly sketch the plate i wanted to analyst... I hope this could help for you, so that u could help me out...
-
Replied #Threads
Stress Analysis Using Autodesk Inventor 2010
I'll post the picture soon... allow to help me out.. thx so much~!!
-
Replied #Threads
Stress Analysis Using Autodesk Inventor 2010
Yesss... Juma~!! this is exactly wat i need... a displacement and stress analysis...
-
Replied #Threads
Circular Plate Bending Moment and Stress
For the manual calculation part i'm done, and the result is quite satisfied... But i need to compare it with my simulation testing using Inventor 2010......
Activity by month
Where maxz contributes
-
#Threads 48 · 100%
Highlights
- Reactions per contribution
- 0.0
- Best answers
- 0
- Member for
- 17 years