Karthik S
@karthik-s-LcNW3O Member
- Member since
- Joined
- Last active
- Active
- Member number
- Member #12,630
- Posts
- 4
- Replies
- 14
- Reactions
- 0
- Active days
- 0
Contributions
Last 12 months
0 contributions
- Active days
- 0
- Longest run
- 0 days
- Current run
- 0 days
Trophies
Featured trophies
0 / 8
Swipe or scroll to see more trophies
-
Replied #Threads
Controlling COM Port using VBA
Thanks buddies.. We are looking for an executable. So we selected VB6.0..😒 Regards, Karthik.. "Rather loose money than trust"
-
Replied #Threads
Embedded-Desktop Integration_VB6.0
Thanks for your inputs Koli.. The difference between RS485 and Rs232 is the reference voltage they work with. As you might know, RS232 takes GND as...
-
-
Replied #Threads
Embedded-Desktop Integration_VB6.0
16 views... But No reply... Is that the question is silly or Complicated? Let reply Buddies...
-
Replied #Threads
5 volt regulator. Surface mount
Hi.. Welcome to CE.. You can get Regulator IC's from MICREL. This suits for your application. Regards, Karthik
-
Replied #Threads
Reading in Data using a microcontroller
Let me tell something.. While using the External Oscillators, we need to set the Oscillator Registers for Type of Oscillator we are using, Baud Rate setting...
-
Replied #Threads
Regulator IC for both +3.3 and +5V
Hi everyone, Thanks for your inputs.. The problem is solved. We decided to use MICREL regulator IC's for 3.3V and 5V. Regards, Karthik.
-
Replied #Threads
Driver for MicroController Outputs
Thanks Ash.. We can use two inverters back to back as a signal driver. But, as per my understanding, it can not be used for longer...
-
Replied #Threads
Driver for MicroController Outputs
Hi Saurav, Thanks for your info... Using BJT is fine... Just we need to take care of this negative logic in programming.. Anyway, thank you very...
-
Replied #Threads
Driver for MicroController Outputs
Hi Amolhshah, I copied the circuit in the previous post. But it's not visible. How can I put a picture in reply?
-
Replied #Threads
Driver for MicroController Outputs
Hi Amolhshah, I simulated a Driver circuit in OrCAD using a transistor as shown below. As we know, the output taken from the collector will be...
-
Replied #Threads
Driver for MicroController Outputs
Thanks Saurav.. But ULN2003 inverts the the Input as per my understanding. 😒 There is no VCC connection in the IC. I'm confused about, How it...
-
Replied #Threads
Driver for MicroController Outputs
Thakyou Amolhshah. I will check it out with ORCAD simulation and let you know.
-
Replied #Threads
Driver for MicroController Outputs
Hi Ash, The Boards are connected through Ribbon Cable..
Activity by month
Where Karthik contributes
-
#Threads 18 · 100%
Highlights
- Reactions per contribution
- 0.0
- Best answers
- 0
- Member for
- 18 years