gsk_ssit

Actually i tried writing the following programs the 'for' loop is giving the correct answer but 'while' loop is not compiling correctly .Can some body explain the following programs.I think...

Hi, I want to join two L-angles one across each other with rivets.My problem is while placing one across each other L-angles gets overlapped so here at this zone thickness...

/* To calculate sum of five digits*/ int num,a,n; int sum=0; system("cls"); printf("Enter a five digit number\n"); scanf("%d",&num); a=num%10; n=num/10; sum=sum+a; a=n%10; n=n/10; sum=sum+a; a=n%10; n=n/10; sum=sum+a; a=n%10; n=n/10; sum=sum+a;...

IssueHere are my suggestions A] For theoretically zero load, you will not need any joint. Only two plates on one another will solve the purpose (See "Successfully constrained motion"). B]However,...

I have 2.6 mm(2+0.6) thickness of plate for lap joint now i want select the rivet dia.How to calculate rivet dia for lap joint.If anybody knows please let me know.assuming...

Does anybody knows how to write a program for geometric Meshing in c/c++/Patran command language.If so please provide me a solution or else suggest some stuffs to get in.

Please suggest good book for MSC patran command language for beginners or websites or any resources....

need tutorials for stress analysis of aircraft wing using MSC Nastran/Patran, i am in cofusion how to apply loads and boundary conditions.Pl help need urgent

is it worth to join for excise subinspector as an mechnical engineer

I have done Mechanical Engineering working as design engineer(Modelling and Detailing) in service company.Now i planned to move towards SAP MM.Because the job what i am doing now is the...