CrazyEngineers
CrazyEngineers
TAMIL AZHAGAR

TAMIL AZHAGAR

Member

TAMIL AZHAGAR is a member of CrazyEngineers since Aug 2, 2014

Member since

Aug 2, 2014

Last active

Apr 28, 2017

Posts contributed

26

Recent posts

Nov 2, 2016
Hi frnds, we are doing a project on tig welding. I need some clarification about the 6 axis robot and welding technique...
Mar 18, 2015
Sree RajDrills are not! But its cutting edges are called "Point",why so?For this fig, not only the point is used for cutting, but also the edges. And here the point...
Mar 18, 2015
A.V.RamaniAs Rishab says above, there is no difference ordinarily. However, when the car takes a turn the wheel on the inside curve has to rotate less than the outer wheel....
Mar 18, 2015
Sree RajThen why there is cutting edges?(principal and auxiliary cutting edges) In case of drills it's not the chisel which is cutting, it is lips! Still called point!Drill bits are...
Mar 18, 2015
hi sir, what abt the left side wheel rotation and that of right side wheel? Is there any difference btw the speed of these two wheels? A.V.RamaniThe driven wheels have...
Mar 17, 2015
Hi frnds, Consider a four wheeler which is lifted from ground. non of it's wheel touches the ground. Now vehicle is started, put on first gear and clutch is released....
Mar 17, 2015
SYMMETRICAL WINGS Most airfoils are cambered, or curved, on top but flat on the bottom. As a result, they fly better upright than inverted. Symmetrical airfoils, which have the same...
Mar 15, 2015
welcome to CE😁
Mar 15, 2015
You just carefully watch the operation using single point cutting tool. In single point cutting tool, only the tip of the tool is used for cutting. while grinding the tool,...
Mar 7, 2015
Hi, is there anyone know ABAQUS? I need some help reg. to that.
Home Channels Search Login Register