Shyamsundar
@shyamsundar-dZmKP4 Member
- Member since
- Joined
- Last active
- Active
- Member number
- Member #150,389
- Posts
- 27
- Replies
- 13
- Reactions
- 0
- Active days
- 0
Contributions
Last 12 months
0 contributions
- Active days
- 0
- Longest run
- 0 days
- Current run
- 0 days
Trophies
Featured trophies
0 / 8
Swipe or scroll to see more trophies
-
Replied #Threads
How to make boot disk?
I want to know for both windows and linux . Method is same right?
-
Replied #Threads
Output Capacitor design for Switched mode power supply.
aruncharyya shamsundar please provide the complete information, capacitor in power supply section or output from other intermediate block section ahh,,..Capacitor in power supply s...
-
Replied #Threads
LC filter design : Cutoff Frequency & L, C Values
ok, but if you start design theoritically , you have to assume the L or C right?
-
Replied #Threads
Opto coupler feedback design
godfatherWhat is your exact application to use optocoupler ?Switched mode power supply, use as feedback network. Iam not getting exact design for this
-
Replied #Threads
Opto coupler feedback design
The_Big_KThat's a good question. Did you attempt at the design on your own? If not, please give it a try and tell us at what stage...
-
Replied #Threads
What is snubber circuit?
The_Big_KThere's a wikipedia article dedicated to the topic. Please have a look- <a href="https://en.wikipedia.org/wiki/Snubber" target="_blank" rel="nofollow noopener noreferrer">...
-
Replied #Threads
What happens if schottky diode is replaced by general purpose diode?
rikilTechnically, Schottky diode has very low reverse recovery time as compared to normal rectifier diode. Your circuit, which I suppose is SMPS, works on may be...
-
Replied #Threads
How to calculate inrush current?
The_Big_KWhy not tell us your thoughts on how can the inrush current be calculated? Share your thoughts so that electrical / electronics engineering experts can help...
-
Replied #Threads
What happens if schottky diode is replaced by general purpose diode?
Scorpion007may be it is concerning with frequency of current because Schottky diode design to work in high frequency current ( even 300 Mhz frequency) but normal...
-
Replied #Threads
How to choose Fuse ?
lalWell, assuming there is only one output for the SMPS, the output power rating is 10W. So input current will be (output + losses)/input current. Neglecting...
-
Replied #Threads
How to choose Fuse ?
Rating of SMPS is 9.6V,1A and power is 9.6Watts...(10 Watt flyback converter topology is used)
-
Replied #Threads
How to choose Fuse ?
lalA fuse works melting by its own when a higher or over rated current flows through it. Fuses are selected based on the Ampere rating for...
Activity by month
Where Shyamsundar contributes
-
#Threads 40 · 100%
Highlights
- Reactions per contribution
- 0.0
- Best answers
- 0
- Member for
- 13 years