CrazyEngineers
CrazyEngineers
ky3orr

ky3orr

Member

ky3orr is a member of CrazyEngineers since Jul 2, 2012

Member since

Jul 2, 2012

Last active

Jul 11, 2012

Posts contributed

11

Recent posts

Jul 11, 2012
Yes, of course. I am investigating now interrupt response on atmega8 now. It seems not to work yet as I expected. So I believe it's just some misconfiguration. Do You...
Jul 11, 2012
No problem, I will surely would like to share something to the community but I need to overcome all problems 😀 I was working now with polling readout of data...
Jul 11, 2012
Bingo! I initialized register 1D with value 0x5 and everything is working. I do have link between two modules and it is possible now to transmit data. It wasn't working...
Jul 11, 2012
#-Link-Snipped-# thanks for that, It's pretty much the same with difference on 1D register and addressing idea. I will check If I could get modules working. BTW: As long as...
Jul 10, 2012
Thanks, right now I am guessing that I might do have a problem because in register 1D bank0 I set only EN_DPL but I guess I also should enable EN_DYN_ACK...
Jul 10, 2012
Yes, SPI is working. It is visible in register dump. Data read from the device is consistent with those used during initialization. I also did example code to see if...
Jul 10, 2012
@#-Link-Snipped-# I was trying to run sample code but it didn;t worked. Is it some special way of setting CE after sending payload to the buffer? I am asking because...
Jul 10, 2012
This is my configuration for receiver (decimal notation). --- Bank 0 --- 0 -> 127 1 -> 63 2 -> 63 3 -> 3 4 -> 63 5 -> 40...
Jul 10, 2012
Ok then, Is it possible for You to do a dump of RFMs register values after power up and after successful configuration? I can't bring those modules to life so...
Jul 3, 2012
#-Link-Snipped-# thanks for answer. My SPI is working and all the stuff i am writing is readable 😀 Today I was going again through list of examples and I've found...
Home Channels Search Login Register