project based on vhdl
Hello all, I am Arun Goel and I am an Electronics Engineer. Please tell me name of the projects based on VHDL. It would be helpful for my final year project submission.
Replies
-
Reya
- VENDING MACHINE
- 16-BIT BARREL SHIFTER
- DMA CONTROLLER
- UART RECIEVER
- BAUD RATE GENERATOR
- TRAFFIC LIGHT CONTROLLER SINGLE WAY
- TRAFFIC LIGHT CONTROLLER MULTIWAY
- 16-BIT MICROPROCESSOR
- BINARY TO BCD\BCD TO BINARY CONVERTER
- FIXED POINT UNIT (ALU)
- FIXED POINT UNIT (COMPARATOR)
- UNSIGNED SERIAL DIVIDER
- 8 BIT MICROPROCESSOR
- UART TRANSMITTER
- HCSA ADDER AND GENERIC ALU BASED ON HCSA
- 32-BIT MICROPROCESSOR
-
AdivyDesign and implementation of Bluetooth security using VHDL
Design and implementation of Ethernet transmitter
VHDL implementation of lossless Data compression
Implementation of electronic voting machine
Design and implementation of Bluetooth receiver
Design and implementation of USART using VHDL
Design and implementation Serial Periphal Interface
Design and implementation of CPU
Design and implementation TDES standard
Design and implementation AES
For more details about VLSI & VHDL check out
Design For Test -
Rupam Dasgo for
"AMBA-AHB" Bus implementation. That is a On-Board Multichip Communication Bust and Bus Controller Protocol. Huge work is going on towards this direction. Worth a Try. -
ayush jainhey, i need a vhdl structural code for barrel shifter.. can anyone help
You are reading an archived discussion.
Related Posts
help me to do my mini and main projects frnds..............
HI....i am studying 1st year mechanical engineering......can any of my seniors give ideas for mini project??.....pls...
Is it possible to make tyres which left or pick metal which causes puncture,damage,etc.,
while driving!
i have an idea,magnet can lift metal but how can it be applicable?😔
from...
Fabrication of queries controlling system for two wheeler
Fabrication of man less defense
GPS based vehicle root tracking system
Fabrication of Two Engine Synchronization for Four Wheeler
Design and development...
Just to say hello to everyone in this forum. Hoping to enjoy it 😀