3 Phase Induction Motor Connection identification

I am using 3 Phase induction motor . When i open the terminal box terminals are identified like U1-U2,V1-V2,W1-W2. Due to short circuit i have to change the terminal box and identification of terminal was eresed . After installation i am not able to identify U1-U2,V1-V2,W1-W2.
So what i have to do for this condition . After that i check winding resistence then connect R-Y-B . I connect the terminal in Delta .

My Question is Is there any method to identified terminal likes before ?

Replies

You are reading an archived discussion.

Related Posts

Following video will introduce you to Gmail's priority mailbox. It's being rolled out to standard Gmail and Google Apps over a course of week - [video=youtube;5nt3gE9dGHQ]https://www.youtube.com/watch?v=5nt3gE9dGHQ[/video]
Please give details of the diferent jsp capable servers.
Stumbled upon this video on Engadget - [video=youtube;03FDr2jFJd4]https://www.youtube.com/watch?v=03FDr2jFJd4[/video]
Mr. Nilekani is ready to roll out the UIDAI project in September in AP state. The project is ambitious and aims to provide unique identification to about 1.2 billion people,...
1.I was connect 3 Phase Induxtion motor in Delta at time i was measured motor speed 1478 RPM 2. Theni was connect motor in start mode at time i measure...