Determine characteristics for a DC motor
Hello guys,
So again I am stuck with my filament winding machine. Since the budget for the project is so small, I have to come by using components which the university allready have.
I got hold of a Nikko 24V 145W DC motor, and that is all. I cannot find any specification sheet on the motor or anything. They do not give its no load speed or torque. So I need to devise a plan to determine these characteristics on my own.
I would like to if you guys have suggestions for me? The one method I found on the internet is to attach the motor to a dynamometer. So I just hope the university have one of these I can use. Do you guys have any other ideas?
Thank you and regards,
Leon
So again I am stuck with my filament winding machine. Since the budget for the project is so small, I have to come by using components which the university allready have.
I got hold of a Nikko 24V 145W DC motor, and that is all. I cannot find any specification sheet on the motor or anything. They do not give its no load speed or torque. So I need to devise a plan to determine these characteristics on my own.
I would like to if you guys have suggestions for me? The one method I found on the internet is to attach the motor to a dynamometer. So I just hope the university have one of these I can use. Do you guys have any other ideas?
Thank you and regards,
Leon
Replies
-
gohmYep, dyno the motor. You can also take it to a place with a dyno and pay to have it done. have you tried the tech division of the manufacture, they should be able to give you the info if you call/ e-mail them.
You are reading an archived discussion.
Related Posts
i am working with 8051 microcontroller.........the relay is connected with 5vdc motor and i am connecting relay at the port p0.0.i am using the following code to rotate the motor..........
Hey, i need help in understanding the function of each components in the circuit or how it works.
https://img3.imageshack.us/img3/7220/cctdiagram.jpg
Any help here would be greatly appreciated.😀
thanks.
Well I am facing a kind of problem.
I was trying to get some hosting plans for a domain name which I had registered some time ago.
Now the person...
I am trying to write a program to initialize General purpose Input Output ports.
The microcontroller I need to initialize the ports on - is a C8051F330 chip.
https://www.keil.com/dd/docs/datashts/silabs/c8051f33x.pdf
I...
I have two dual axis ADXL203 accelerometers. However, I am supposed to get acceleration data in three dimensions. My professor advised me to get dual axis instead of triaxial accelerometers...